top of page

Water softeners: what they do, what they don't, and the rules

Writer: Szymon Wielinski
Szymon Wielinski
7 days ago
3 min read

Almost every home in London and north Surrey has hard or very hard water. A water softener is the only common household treatment that takes the hardness out of all the water in the house. This guide explains what it does, what the evidence says, and the rules for fitting one.

How a softener works

An ion-exchange softener passes your water through a resin that swaps calcium and magnesium for sodium. Every few days the unit cleans the resin with brine made from the salt you add. The result is water that leaves little or no limescale.

What softening does

  • Stops new limescale forming in kettles, showers, taps, cylinders and the hot water side of a combi boiler.

  • Lets soap and detergent lather more easily, so you use less.

  • Keeps shower screens, taps and tiles cleaner for longer.

Limescale is a real issue for heating systems in this area. Boiler commissioning checklists ask the installer whether the property is in a hard water area (above 200 ppm) and, if so, which scale reducer has been fitted.

What the evidence says about skin and eczema

Many people buy a softener hoping it will help eczema. The Softened Water Eczema Trial, led by the University of Nottingham, tested this with 336 children with moderate or severe eczema living in hard water areas in England. The trial found no objective difference between children whose homes had a softener and those that did not. Parents reported small improvements, but the nurses who assessed the children, without knowing which group they were in, did not see a difference.

Drinking softened water

The DWI advises keeping an unsoftened supply to the kitchen tap for drinking and cooking. Some softeners add significantly to the sodium in the water, and the drinking water regulations set a sodium limit of 200 milligrams per litre. Softened water should not be used to make up baby feeds. The DWI also notes that very soft water, at or below 100 milligrams per litre, can be more corrosive to metal pipes and fittings.

For these reasons we fit a separate unsoftened tap for drinking and cooking with every softener.

Softener or scale reducer?

A scale reducer fitted on the cold supply to a boiler or water heater is a cheaper way to protect one appliance. It does not soften the water elsewhere in the house. A softener treats everything downstream of it.

Fitting and upkeep

  • A softener is connected to the incoming main with a bypass valve, so the water can stay on during servicing, and needs a drain for the regeneration water. Most need a power socket.

  • The installation must comply with the Water Supply (Water Fittings) Regulations 1999.

  • Salt needs topping up, and the DWI recommends regular servicing. A unit left unused, for example in an empty property, may need servicing before it is used again.

  • It needs a frost-free space: under the sink, in a utility room or in a heated garage.

Guide prices

Supplied and fitted, before we see the job. The exact price comes after a survey visit.

  • Water softener with bypass and a separate unsoftened drinking tap: typically £1,100 to £2,200.

  • Softener and whole-house filter together: typically £2,000 to £3,800.

Salt and servicing are extra.

Is a softener worth it for your home?

It depends on how hard your water is, how much limescale is costing you in appliances and cleaning, and whether you want soft water at every tap. Read what is in tap water and the legal limits and our guide to water filters, then book a survey visit (£150). We test your water, check the space and drainage, and send a written quotation. See our water filters and softeners service.

 
 
 

Comments


bottom of page